For Y'all Jointer Planes.

I'm making a minor batch of jointer planes, her's ane beingness glued upwardly amongst the aid of 17 bar clamps!

The get-go cutting on the ring saw defines the profile.

The shaping cuts start to cast the curves as well as ane time to a greater extent than this is done speedily (and carefully) on the ring saw.
The pile of dust on the tabular array is what happens when you lot forget to opened upwardly the right nail gate on the extract ducting!

This is the outcome afterwards fossil oil sanding on the bobbin sander, a much used machine inwards my workshop (I accept two).

These are shots of box beingness made inwards Republic of Ireland using my magnetic guide, the dovetails hold off overnice as well as clean. It's odd to accept only ane dovetail but looks quite effective, it may last likewise if epoxy resin is used on the halt grain to avoid gaps opening upwardly at the corners.

Share this post