For You Lot Drawer Fitting

I've been able to pass a piffling to a greater extent than fourth dimension on the walnut breast in addition to amongst the drawers glued upwards it was fourth dimension to carefully check each drawer. I made a overnice tight drawer back upwards from 1" ply, to ensure the sparse sides were fully supported in addition to didn't flex during planning, higher angle planes amongst a super tight rima oris were needed to avoid tear out on the highly figured sides.

When I larn to a greater extent than or less the required check I role sandpaper for lastly tuning, it's amazing how slow it is to become likewise far!

The drawers are fitted from the rear, this should larn into quite easily equally the bring upwards is a shade wider than the front, come across previous posts for the process.

The check at this phase makes certain the drawer tin come upwards out of the forepart only yet binds a piffling at the rear. Final plumbing equipment volition live done amongst the drawer bottoms inward place.

The walnut is looking gorgeous, I can't hold off to larn some complete on!

Share this post