For You Lot Walnut Breast Continued

Time to cutting the tails. Rather than belongings the board horizontally, I angled it to 1:6 hence that the cuts would survive made vertically, in that place was no demand to grade inwards the angles first. This was a tip from the Barnsley Workshops.

Angling the board the other agency allowed me to cutting the other side, i time again on the vertical.

I used my wonderfully made 'long stroke' dovetail saw made past times Skelton saws. It cutting hence cleanly together with chop-chop I didn't choke a peril to current of air it upwards together with brand or hence long strokes!

The check together with complete of the saw is faultless.

I dry out fitted the shelves together with cutting the curves on the drawer supports, cleaning upwards alongside a apartment soled HNT Gordon spoke shave, a wonderful tool. Each of the shelves was recessed from the carcass sides past times 1 mm, greenback the flake pieces standing inwards for the dorsum which volition survive cutting to a check afterward the carcass has been glued up.
With all the dovetails cutting together with fitted, the finally undertaking for the twenty-four hr catamenia was to sand together with complete all the internal surfaces arrive at for mucilage up. I used 2 coats of manus applied melamine lacquer, cutting dorsum alongside an Abralon 600 pad together with finished alongside a coat of Gilly Stephenson's Cabinet Makers Wax alongside a high carnauba wax content. The finally waxing volition human activity every bit a resist, making mucilage mash out tardily to popular off every bit good every bit giving a prissy smoothen surface for the drawers to piece of job on.

Share this post